This is just a poll of where you have worked, whether co-op, intern, or full time. I always hear that you can't get out of the midwest if you go to school at UMR, so I am just curious where everyone has been, is going...

Intern:

Southern Cast Products--Jonesboro, AR
US Steel--Gary, IN

Full time in December:

Carpenter Specialty Alloys--Reading, PA

Internship last summer:

Garmin International--Olathe, KS

Interned at:
Horizon Engineering Associates, LLP
30 Broad St.
NY, NY 10004

ATK Lake City
Independence, MO

Although I was offered a spot at ADTRAN, Inc.
Huntsville, AL which I don't consider midwest.

intern at Olsson Associates-springfield MO

2 summers with Denso International America Inc. in Southfield, MI

I interned at Dynetics Inc. in Huntsville, Al.

2 summers with Group in Loveland, CO

Had internships with:

-Dyno Nobel Explosives

-Rinker Materials

Two internships with NASA at Marshall Space Flight Center, near Huntsville, Alabama.

Turned down a job offer from Sandia to pursue my PhD.

Interned the past 2 summers at Enterprise Rent-A-Car in St. Louis, so no, I didn't get out of the midwest, but I didn't try to. I prefer STL.

Naval Warfare Center - Port Mugu, CA

Interns at:

Jacobs Engineering - Structural Engineer
SCI Engineering - Soil Consultant

Interns at:

US NRC - Rockville, MD (just ouside DC)
US NRC - Arlington, TX (between Dallas/Ft. Worth)

If I don't go to grad school after graduation:

Bettis Atomic Power Lab (probably) - Pittsburgh, PA

GE Global Signaling in Blue Springs, MO

By the way, how is Dynetics? I have an interview with them.